DESCRIPTION: The "Cool
point CWPT" models are a single
package unit designed for use with
duct-work for efficient air distribution.
This unit is completely wired, piped,
charged and run tested in the factory
before shipment to minimize installation
time. Special features are incorporated
to protect the unit from potential
damage due to power supply fluctuations.
Its super quiet compressor operation
makes the unit suitable for almost
any outdoor location, rooftop or ground
level. Unit is designed to cool practically
any residential, commercial or industrial
buildings.
FEATURES:
Cabinet -The fabricated sheet metal components
are constructed of galvanized steel. After
fabrication, each part is bonderized to
remove any grease or dirt from its surfaces.
The external parts are then coated with
zinc phosphate and finished with a high
quality baked enamel to make them resistant
to weathering and corrosion.
Base
Rails - provide
a solid foundation for the entire unit.
The rails have forklift access and rigging
holes to acilitate handling and to simplify
installation.
Highly
Efficient Unit
- low power input is achieved by specially
developed Coils and carefully selected
compressors and motors.
Highly
Efficient Coils
-combination of finned tube and have been
used on both evaporator and condenser
coils.
Dual
Refrigeration System
- provides exceptional part load performance.
Completely independent refrigeration system
and electrical circuits provide continuous
operation should one circuit fail (on
multiple compressor).
Quiet
Operation
- with the adoption of new hermetic compressor,
the noise and vibration have been effectively
reduced. Also, larger and softer mounting
ISO later has been used to absorb the
energy being transmitted in the form of
vibration.
Compressor
Crankcase Heater
- each compressor is equipped with a crankcase
heater to prevent refrigerant from mixing
with crankcase oil during the "off"
cycle.
Time
-delay Circuit
- positively prevents short cycling of
compressor by delaying re-start after
a power failure or control circuit interruption.
High
Pressure Control
- automatically stops the unit if unusual
operating conditions cause the discharge
pressure rise above the setting. It protects
the compressor from excessive condensing
pressures.
Low
Pressure Control -
automatically shuts off the unit if suction
pressure falls below setting. it provides
loss of charge and freeze-up protection.
Compressor
Built-in Overload Protector
- gives fast responsive protection against
both abnormal temperature and excessive
current thereby assuring years of dependable
operation.
Extra
Efficient Fan Blade
- propeller fans are precisely matched
with the extra strong fan motors to ensure
efficient hot air dissipation.
Built-in
Air Filter
- units has built-in cleanable. air-filters.
Specifications:
Model
HP
Cooling
Capacity
Air
Flow
CFM
Dimensions-inches
Weight
(Kg)
Btus/hr
Kcal/hr
Length
Width
Height
CWPT-5
5
51800
13000
1850
42o
52o
40.5o
355
CWPT-7.5
7.5
84390
21255
2500
47o
74o
40.5o
410
CWPT-10
10
103600
26096
3400
56o
86o
41o
538
CWPT-15
15
168780
42514
5700
66o
74o
48o
830
CWPT-20
20
207200
52100
6800
75o
110o
50o
1000
CWPT-25
25
259000
65200
8000
75o
110o
50o
1200
Note:
1 - Specifications are subject to change
without notice.
2 - All units are suitable for 380/3/50
or 220/1/50 supply.
